Scanner not picking up ECU, code p2367

2016 VOLKSWAGEN POLO
103,000 MILES • 1.4L • 4 CYL • 2WD • AUTOMATIC
Avatar
TIMMYGOV
  • MEMBER
  • 1 POST
No communication with engine ECU, but transmission ECU okay. Cannot identify engine ECU but transmission can p2367 on. Check entire wiring and sensors and fuses. Gearbox locked in limp mode on third gear. It is an automatic.
Nov 30, 2018 at 3:54 PM
Advertisement
Avatar
STEVE W.
  • ✓Experienced Mechanic
  • 15,381 POSTS
P2367 is a no communication CAN bus error code. It would be set if there is an issue with any of the modules that use that data bus. About the only way to test it would be with an oscilloscope to see the CAN signal and then determine which module is pulling the CAN bus down. If the engine is still running it is likely not the ECU but another module that is causing the problem.
Dec 4, 2018 at 1:51 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle