Right blinker does not work

2008 CHEVROLET TRAILBLAZER
227,000 MILES • 4WD • AUTOMATIC
Avatar
RRA
  • MEMBER
  • 1 POST
My right blinker started off not working, and then quit completely and then went back to working off and on. So I took it in and had a diagnostic test done and was told it was the multi-function switch that a wire on it was bent and no good. We replaced it and it is still doing the same thing. Could it be the relay switch? Checked the fuses and they were good but replaced them anyways. Need some help. Thanks!
Nov 18, 2017 at 8:14 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,193 POSTS
  • ASE Certified Mechanic
If the signal comes on and does not flash, replace the flasher. If nothing happens when you use it, the fuses are good. you need to start tracing wires to see where the power is lost. Not a fun job but has to be done.
Nov 18, 2017 at 9:15 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.