Rebuilt front right suspension, installation issue

2003 DODGE RAM
198,000 MILES • 4.7L • V8 • 4WD • AUTOMATIC
Avatar
JPOPE8
  • MEMBER
  • 1 POST
replaced lower and upper control arm shock wheel hub and sway bar link on right front. finished it was to low about 3 inches lower than left side. jacked it back up torsion bar and key wont line up and when we get it to line up it's too loose. need help in figuring this out. It's my only driver and been down 4 weeks. thanks
Feb 21, 2021 at 2:19 PM
Advertisement
Avatar
KASEKENNY
  • CERTIFIED EXPERT
  • 18,907 POSTS
I am not sure I understand what you mean by the torsion bar and key won't line up. The torsion bar is what sets the ride height so if it is too low then you don't have the adjustment bolt set correctly.

I attached the process below from the manual. Let me know if you can get some pictures of this and that may help get us on the same page. Thanks
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Feb 22, 2021 at 6:27 PM