1991 Porsche 911 Noise in moter/transmission

1991 PORSCHE 911
450,000 MILES • 6 CYL • AWD • MANUAL
Avatar
MIKEBLANKENBAKER
  • MEMBER
  • 1 POST
There is a loud clunk when starting or when turning the engine off. I have heard it on both sides of the motor. It's been suggested that it maybe that the fly wheel is loose. I am just guessing that it may be related to the all wheel drive..transfer case connections.. Just a guess Any idea???
Aug 3, 2010 at 11:09 PM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Hi there,

I would be getting the drive shaft checked first.

mark (mhpautos)
Aug 4, 2010 at 2:32 AM
Avatar
CWPORSCHE
  • EXPERT
  • 58 POSTS
If its a manual transmission then what you likely have is a worn whats called a dual mass flywheel. This flywheel contains a heavy fluid that prevents engine oscillations from transmitting thru the trans.Over time the oil escapes out causing the internal components to hit their end stops,thereby creating the knocking noise.An experienced tech knows how to check for wear.Replacing the flywheel will fix the noise.
Aug 5, 2010 at 11:22 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.