1995 Plymouth Voyager won't stay running

1995 PLYMOUTH VOYAGER
140 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
NESTEGG
  • MEMBER
  • 1 POST
my daughter's van has had fuel pump replace...map sensor....she put dry gas in it it started ....she left it run for about 10 min....and when she stepped on gas to move it died...she tried to restart it wouldn't .....another day she tried again same thing....she had someone looking at it there saying it might be timing chain.....would that happen ...do you have any suggestions....she is a single mother of 4 and cannot afford to take it to a dealer
Nov 3, 2008 at 6:00 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Hi:
It could be timing, but usually when the chain or belt goes bad, it doesn't run at all. Did she have the fuel pump relay checked?

Joe
Nov 4, 2008 at 10:52 AM
Avatar
PATRICE MAYO
  • MEMBER
  • 1 POST
1995, 3 Liter v-6 engine, just stops running. It's like it loses pressure and you can hear the engine strain if foot is on the gas. Release the gas pedal and you might go another mile, but then it hust dies and will not start. Flicking the key in the on position a few times might get it to start, but before you can put it in gear it dies again. Did a complete tune-up: oil change & filter, spark plugs and wires, fuel filter, replaced alternator belt. Want to know could it be the fuel pump or does the fuel pump have a relay of it's own. Then is it the catalytic converter? I've used the gas treatments twice to a quarter tank of gas, but no change. Any suggestions?
Apr 5, 2016 at 11:56 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.