1967 Plymouth Fury Starting my Car; thats been sitting on a

1967 PLYMOUTH FURY
Avatar
M190908M
  • MEMBER
  • 1 POST
Engine Mechanical problem
1967 Plymouth Fury 6 cyl Two Wheel Drive Automatic alot miles

My 1967 plymouth fury III has been sitting on the hill too long, and i went out to start it up, and well, it didn't.
I was told you could start a car that won't start by pouring a shot full of gasoline into the carburetor, and starting your car. Does this actually work? How would i go about doing this? I heard its because the engine loses pressure over time by sitting on a hill. Could use any help, thanks.
-matt

If I get an answer, I'd be more than happy to donate? =) $$$$$$$$$$$$$$$$$$$$$$$$$$$$ oh yeah
May 4, 2009 at 6:31 PM
Advertisement
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Check all your fluids make sure its on full and good condition. Once all completed-Attempt the gas thru the Carb and tell me what happened.

Does it have the conventional distributor or Electronic?
May 4, 2009 at 8:40 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.