1988 Plymouth Colt WONT DRIVE WHEN IN GEAR

1988 PLYMOUTH COLT
117,190 MILES • 4 CYL • FWD • MANUAL
Avatar
TRAVLINMAN_17
  • MEMBER
  • 1 POST
MY 88 PLYMOUTH COLT WONT DRIVE WHEN I PUT IT IN GEAR IVE ALREADY MADE SURE THE BRAKE IS RELEASED IT SEEMS LIKE THERE IS JUST ALL OF A SUDDEN LOST ALL OF ITS TORQUE
Jan 10, 2010 at 4:11 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,367 POSTS
Does the engine stall when you let the clutch out? If not, suspect a problem inside the transmission or a broken inner cv joint on one of the half shafts. Could be a broken outer joint too, but the spinning shaft would make a horrendous noise when you released the clutch.

caradiodoc
Jan 12, 2010 at 7:01 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.