P0304 code is displayed

1998 BUICK CENTURY
72,000 MILES • 3.1L • 6 CYL • FWD • AUTOMATIC
Avatar
RON ELLIOTT
  • MEMBER
  • 1 POST
I have replaced the cylinders one and four coil pack, but the P0304 code returns along with stuttering at highway speed.
Apr 24, 2017 at 6:55 AM
Advertisement
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Were the spark plugs checked or replaced? It could also be from a fault with the injectors. Have those checked. Apart from these, it could also be from loss of compression.
Apr 24, 2017 at 8:06 AM
Avatar
STEVE W.
  • ASE Certified Mechanic
  • 15,200 POSTS
  • ASE Certified Mechanic
Test one, remove both the one and four plug wires. Turn over the engine while watching the coil pack. It will spark between the towers if it is firing. (as it is only showing P0304 it is likely firing as that engine uses a waste spark system that fires two cylinders at the same time off each coil).

Next pull the plug wire from number four and hold it close to the top of the plug (use insulated pliers, not your fingers!) Look and listen for the spark. No or weak spark = bad wire.
Good spark = bad plug.
If the above checks out you will need to test the injector to see if it is putting out fuel, and/or check for compression.

Apr 24, 2017 at 9:24 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.