1988 Oldsmobile Cutlass noise and fly wheel

1988 OLDSMOBILE CUTLASS
100,805 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
RHONDA RAYMOND
  • MEMBER
  • 4 POSTS
I accuried this car today,I drove it aproximatly 5 miles. at first it wouldn't stay running due to sitting a few months, then as we were driving I heard a sputtering noise, kinda like someting was hitting the fan. It ran good a lot of power ,but when we got it home and started looking at the engine, after checking the airconditioning the fan quit spinning, whats the problem?
Mar 9, 2008 at 10:12 AM
Advertisement
Avatar
MASTERTECHTIM
  • Experienced Mechanic
  • 4,750 POSTS
sounds like the fan is no good. did you see if it will spin by hand and feel if it is wobbling or seized?
Mar 9, 2008 at 10:14 AM
Avatar
RHONDA RAYMOND
  • MEMBER
  • 4 POSTS
[quote:aa87a4445f="rhonda raymond"]Engine Mechanical problem
1988 Oldsmobile Cutlass 6 cyl Front Wheel Drive Automatic 100805 miles
----------------------------------------------------------------
I accuried this car today,I drove it aproximatly 5 miles. at first it wouldn't stay running due to sitting a few months, then as we were driving I heard a sputtering noise, kinda like someting was hitting the fan. It ran good a lot of power ,but when we got it home and started looking at the engine, after checking the airconditioning the fan quit spinning, whats the problem?[/quote:aa87a4445f]

you guys were awsome helping me with my heater core,thanks to you guys I got it fixed myself without taking it to a shop,

thanks,

Rhonda
Mar 9, 2008 at 10:14 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.