Not getting up to temperature

Has someone removed your thermostat?
If not, have you tried a new thermostat?

Not sure if it has been removed. I will try and install a new one this weekend . Thanks for the quick reply . Will let you know next week.

Here is a guide to help you see what you are in for when doing the job:

https://www.2carpros.com/articles/replace-thermostat

and

https://www.2carpros.com/articles/car-is-leaking-coolant

Please let us know what happens.

Cheers, Ken

Thank you this should help a lot.

Ok got new thermostat in getting up to temp but still blowing Luke warm air . Any suggestions?

feel both heater hoses going into the firewall under the hood to the heater core, they should both be hot once the engine is up to temp, if one is hot and the other luke warm, then your heater core is clogged. If so, you could try a backflush before having to replace the heater core.
If both hoses are just luke warm, check to see if there is a heater control valve on either heater hose that might be stuck closed, so if it has a heater control valve, check both the heater hose before and after that valve, they should both be hot.

I've been playing around and found that the temp does not change when moving from cold to hot .found blend door motor and it moves maybe a 1/8 of an in when moving dial

That has got to be the problem then. I suspect both heater hoses were hot then.

Yes they were .

I think you found the problem.

Thanks to everyone for the help

You are welcome...