no voltage to the fuel pump

1996 FORD PROBE
2.8L • 6 CYL • 2WD • MANUAL
Avatar
BNEWCOMB
  • MEMBER
  • 1 POST
I replaced fuel pump, but still no power to fuel pump when turning key. Also took out the inertia switch to be on safe side and just connected the two wires together. No blown fuses. Relay checked ok. When bridging the F/P and GND terminals on the data link connectors(test block), fuel pump comes on. I also changed out the PCM, still no voltage to fuel pump. Only when I jump the F/P and GND terminals. What could be my problem?
Apr 12, 2015 at 6:16 AM
Avatar
SATURNTECH9
  • ✓Experienced Mechanic
  • 30,869 POSTS
So when your checking for power at the fuel pump connector that plugs into the fuel pump are you just checking across the power and ground terminals of the connector going to the fuel pump with the meter leads?I need to know because iam not there to see what your doing.
Apr 12, 2015 at 7:19 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle