No start, no crank

2000 PONTIAC MONTANA
193,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
MICHELE ZWOLINSKI
  • MEMBER
  • 2 POSTS
I just replaced the ignition cylinder and my van started three times. Took a break and one hour later I have a no crank no start condition. Tried to jump the battery still no crank no start.

Could it be the new cylinder? Or just my battery?

How do I reset the sec system just in case that's it?

Michele
Jan 17, 2019 at 6:36 PM
Advertisement
Avatar
MICHELE ZWOLINSKI
  • MEMBER
  • 2 POSTS
Update: I removed the new ignition cylinder and put the old back in and it works. started right up.
Jan 18, 2019 at 6:32 AM
Avatar
STRAILER
  • ✓ASE Certified Mechanic
  • 54,837 POSTS
  • ASE Certified Mechanic
The new key needs to be coded for the car. the dealer can do it before you install it if you bring your VIN number with you and proof of ownership. When the car would not start did the security light flash?
Jan 19, 2019 at 11:33 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.