Nissan Altima 2004 Axke

2004 NISSAN ALTIMA
Avatar
KMCH61498
  • MEMBER
  • 1 POST
We recently ran into a huge pot hole and had to replace the front left strut. It turns out that not only was the strut damaged but also the axle. We have a choice of replacing the axle with a new one or having it rebuilt. I am not too comfortable with rebuilted parts on cars; I believe they will eventually cause problems and more expense. What is your opnion; should I get a new one or rebuilt?
Jan 25, 2006 at 6:17 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,189 POSTS
If you stick to quality rebuilt parts you should be ok. The problem with drive axles is if you were to buy new the cost would be about $550.00. You can get a rebuilt unit from amazon for about $89.00. Re-manufactures replace the CV joint balls and worn parts with new units. Reassemble with new CV boots and you are ready to go.
Jan 28, 2006 at 4:45 PM
Advertisement