need to get power to 1/4 & 2/6 wires going to the coil pack

1997 DODGE INTREPID
200 MILES • 3.3L • 6 CYL • FWD • AUTOMATIC
Avatar
MAXWELLHART
  • MEMBER
  • 4 POSTS
I am getting power to my 3/5 cylinder wire coming off the wire harness but not from the wire for 1/4 & 2/6 coming off the wire harness what all do I need to check I already changed the pcm.?
May 29, 2014 at 9:17 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
you need to scan for codes first to see what the cause is.
May 29, 2014 at 9:32 AM
Avatar
MAXWELLHART
  • MEMBER
  • 4 POSTS
i scan the pcm and they are no codes.
May 29, 2014 at 10:15 AM
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
actually iforgot there won't be because you got rid of theone that had it stored. check your cam and crank sensors for resistance against new ones. check orange wire on crank sensor for 5-8 volts if voltage more than 7 volts replace cam sensor. ifnot that have a pro look at it. Also check your asd relay it may also be the cause switch with a like relay.
May 29, 2014 at 12:09 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.