1991 Mitsubishi Truck mighty max truck brakes

1991 MITSUBISHI TRUCK
135,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
ADKRIC
  • MEMBER
  • 1 POST
as you drive about 5 miles or so the brakes start to have pressure on them dragging against the motor. if you stop and wait the brakes will bleed off and you can go again or you can open a bleeder valve and drive a little futher? it appears to apply pressure mainly to the front brakes but you bleed it at the block going to the rear shoes
Aug 19, 2009 at 6:50 PM
Advertisement
Avatar
MHPAUTOS
  • ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Hi there,

Check that you have some pedal free play, this is very important, if that is ok, you may have deteriorating (internal linings collapsing) front brake hoses that are closing foo and holding some residual pressure, check these first.

mark (mhpautos)
Aug 19, 2009 at 8:47 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.