1999 Mitsubishi Galant starter removal

1999 MITSUBISHI GALANT
Avatar
REY2113
  • MEMBER
  • 1 POST
Engine Mechanical problem
1999 Mitsubishi Galant 4 cyl Front Wheel Drive Automatic ? miles

how to remove the sarter
Jan 13, 2009 at 7:02 PM
Advertisement
Avatar
BMRFIXIT
  • ✓ASE Certified Mechanic
  • 19,053 POSTS
  • ASE Certified Mechanic
General procedure

Removal & Installation
1.Disconnect negative battery cable. If necessary, raise vehicle on hoist.
remove engine under cover and skid plate, if equipped.
Remove right-hand engine mount heat protector.
Disconnect and label vacuum hoses from transfer case shift actuator.
Remove pin from actuator operating rod and remove actuator.
2.On all models, remove starter mounting bolts and starter. To install, reverse removal procedures.
ensure vacuum hoses to actuator are properly attached (Blue hose to outside surface; Yellow hose to bottom of unit, under operating rod bellows).
Jan 13, 2009 at 7:46 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.