1989 Mazda Truck Head Gasket Installation

1989 MAZDA TRUCK
156,000 MILES • 4 CYL • 2WD • MANUAL
Avatar
SSBRIGGS1996
  • MEMBER
  • 2 POSTS
When installing a new head gasket, should anything be used between the head and the gasket? Would the use of an adhesive or gasket sealer cause gasket failure?
Jan 27, 2009 at 7:41 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
You do not use anything between the head and the gasket-just make sure all mating surfaces are thoroughly cleaned
Jan 27, 2009 at 7:53 AM
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
Hi there,

There is no need to use a sealant, modern head gaskets have a built in sealant, just torque down as instructed and replace the head bolts if they are torque to yield and don't attempt to re torque after installation, make sure that both surfaces are clean and no trace of carbon or old gasket is visible.

Mark (mhpautos)
Jan 27, 2009 at 7:54 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle

Advertisement