2000 Mazda Protege

2000 MAZDA PROTEGE
Avatar
TOM HOLZ
  • MEMBER
  • 1 POST
Electrical problem
2000 Mazda Protege 4 cyl Front Wheel Drive Automatic

The cruise control doesn't work, the light doesn't come on and the CC does not engage
Jul 9, 2010 at 1:19 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DAVE H
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 13,384 POSTS
SELF-DIAGNOSTIC SYSTEM
One of two on-board diagnostic modes may be utilized. The CONDITION DETECTION MODE indicates trouble in cruise control system. The OPERATION MODE checks correct input signals to the cruise control module. Modes are performed using either the New Generation Star (NGS) tester or cruise indicator light.
Perform OPERATION MODE first. If system passes all operation modes, perform CONDITION DETECTION MODE. If condition detection mode does not output any DTCs, check components in the following order: main switch, cruise control module, cruise brake switch, brakelight switch, cruise control switch, actuator, and vehicle speed sensor. See COMPONENT TESTS. If no components are defective repair wiring as necessary. See WIRING DIAGRAMS.
Jul 18, 2010 at 8:19 PM
Advertisement