1990 Mazda 626 Clutch issue

1990 MAZDA 626
Avatar
WINVIPER00
  • MEMBER
  • 1 POST
Transmission problem
1990 Mazda 626 4 cyl Front Wheel Drive Manual

My clutch in my 1990 mazda 626 has been giving me problems. The clutch was working perfectly fine, and then started getting stuck. As to where the clutch won't come back up after being depressed down, not allowing me to change gears. And it goes in and out from working to broken every now and again and is now not comin back up from the floor board. A Friend told me it could be the slave cylinder that needs to be replaced, or the fluid needs to be flushed. Any answers?
Oct 26, 2010 at 4:52 PM
Advertisement
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Start by checking the clutch master cylinder and then the slave
Oct 26, 2010 at 5:53 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.