1998 Lincoln Continental Rear Passenger Brake Light

1998 LINCOLN CONTINENTAL
Avatar
SMILES99
  • MEMBER
  • 2 POSTS
Electrical problem
1998 Lincoln Continental V8

I need to replace the rear brake light bulb. Can anyone tell me where to start. I do not see any where to remove any screws, just one long cable going into the firewall to the lens.
Jun 18, 2009 at 8:47 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MERLIN2021
  • CAR REPAIR CONTRIBUTOR
  • 17,250 POSTS
Open the trunk, remove the plastic buttons that hold the trunk interior trim to the rear section, remove the trim, there should be a pigtail or two that twist off, pull the bulb out and replace. Install is the reverse.
Jun 18, 2009 at 4:04 PM
Advertisement
Avatar
SMILES99
  • MEMBER
  • 2 POSTS
Actually after trial and error you have to remove 5 bolts. The entire light casing comes out and you then have to pull the light out to replace.

thanks anyway.
Jun 18, 2009 at 9:42 PM