Fuel Sending Unit Wiring?

1993 JEEP WRANGLER
120,000 MILES • 4 CYL • 4WD • AUTOMATIC
Avatar
BLOUGH28
  • MEMBER
  • 1 POST
I broke my clips to connect my 1993 jeep wrangler 4.0L to the fuel sending unit and i cannot figure out how the wires go together to make it work again. So my question is what wires do i connect to get it to work? The important thing is get it to run but i cannot figure out how to combine the wires to make it run. Any help will be appreciated

Thank You
Adam
Sep 1, 2010 at 10:05 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RACEFAN966
  • CAR REPAIR CONTRIBUTOR
  • 5,029 POSTS
Ok first I would see if I could buy a new pigtail either from the dealer or wrecking yard. I did include a pic of the wiring that does include the sending unit and fuel pump operation I hope you can read it ok. It looks like there are three wires. Check out the images (below). Let us know if you need anything else.
Image (Click to enlarge)
Attached Media
Sep 1, 2010 at 10:46 AM
Advertisement