1992 Jeep Wrangler hydrolic clutch

1992 JEEP WRANGLER
Avatar
CHADTC
  • MEMBER
  • 2 POSTS
Transmission problem
1992 Jeep Wrangler 4 cyl Four Wheel Drive Manual

i asked about my clutch pedal or lack there of yesterday but put in the wrong year by mistake. i dont have a 2002, i have a 1992. i have put a new clutch in including the internal slave cylinder and bled the line several times but cant seem to keep any pedal pressure. it works ok rite after bleeding it but i have to pump it several times once i get down the road. please help still shiftless.
Feb 10, 2010 at 6:09 AM
Advertisement
Avatar
2CARPRO JACK
  • ✓ASE Certified Mechanic
  • 11,533 POSTS
  • ASE Certified Mechanic
No problem. same applies
Sounds like the only part left is the clutch master.It is just like a brake master and can suck air in if the seals start going bad.If you have a pedal, then you have most likely bled it properly, for it to go away means air is being introduced into the system. Look at the back of the master under the dash for any signs of leaking or sweating where the rod goes in from the pedal, this isnt 100% but usually a good indicator of the problem
Feb 10, 2010 at 7:07 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.