1990 Jeep Wrangler clunking when making left turns and over

1990 JEEP WRANGLER
13,000 MILES • 4 CYL • 4WD • MANUAL
Avatar
LMPRICE
  • MEMBER
  • 1 POST
but the shocks are in-tact and still good. doesnt make any noise when its shut off and you push on the jeep to make it shake up and down. if you move it side to side it makes the noise alot
Dec 18, 2008 at 12:51 PM
Advertisement
Avatar
MECHCURT
  • MEMBER
  • 184 POSTS
Check to make sure the tracking bar bushings are good. The bar runs from the passenger side axle up and to the frame on the drivers side, these wear out. If its tight you will have to just check out the entire front end. Let me know what you find out. Curt
Jan 2, 2009 at 3:58 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.