1994 Other Jeep Models Turn signals

1994 JEEP
180,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
BIGPUNFU
  • MEMBER
  • 3 POSTS
i had my turn signals stop working so i checked the fuses and all were fine. i checked the switch and changed it and that didnt work. i changed the relay and that worked but as soon as the flashers were turned off, there was an audible buzz that stayed on as long as the turn signals and or hazards were turned off
Apr 11, 2009 at 6:09 PM
Advertisement
Avatar
JAMES W.
  • ✓ASE Certified Mechanic
  • 2,394 POSTS
  • ASE Certified Mechanic
Sounds like you need a flasher. It sould be located on the underdash fuse block.
Apr 11, 2009 at 6:44 PM
Avatar
BIGPUNFU
  • MEMBER
  • 3 POSTS
that would cause the relay to buzz?
Apr 11, 2009 at 6:58 PM
Avatar
JAMES W.
  • ✓ASE Certified Mechanic
  • 2,394 POSTS
  • ASE Certified Mechanic
Relay will "buzz" due to bad coil or contacts. low voltage to the coil is sometimes will cause this, but it's usually a bad coil.
Apr 11, 2009 at 9:49 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.