2000 Jeep Cherokee ignition switch

2000 JEEP CHEROKEE
150,000 MILES • 4 CYL • 4WD • AUTOMATIC
Avatar
JOHN BABINEAUX
  • MEMBER
  • 1 POST
The car would not stop running after the key was turned to off. I replaced the ignition switch and it would not turn over or start. The next day for some mysterious reason it did start and turn off properly. Three hours later it would not turnover or start. Do you have any suggestions ?


Thanks for your support

John
Aug 30, 2010 at 6:32 PM
Advertisement
Avatar
BLUELIGHTNIN6
  • ✓ASE Certified Mechanic
  • 16,542 POSTS
  • ASE Certified Mechanic
did you replace the actualy switch or just the lock cylinder? seems like switch itself is probably at fault or loose wiring.
Aug 30, 2010 at 7:23 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.