1998 Jeep Cherokee abs light

1998 JEEP CHEROKEE
90,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
JARNICA
  • MEMBER
  • 1 POST
Why does the abs light come on for an extended period of time , then go back out? Mechanic checked on his computer and found a code for "low voltage to pump"... Could this be a faulty control module? Or should I have the abs sensors at each wheel tested for voltage?
Apr 6, 2009 at 7:57 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
If it was a sensor at the wheels, it would have identified that. Did the mechanic test the power to the pump? That is where I would start. There could be a loose or corroded wire.
Apr 7, 2009 at 7:57 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.