1996 Jeep Cherokee camshaft position senor A circuit (bank

1996 JEEP CHEROKEE
47,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
96CHEROKEE
  • MEMBER
  • 3 POSTS
I have a 96 cherokee 4.0 . it starts and then stalls as i am driveing , I used my scan tool obd2 and got code P0340 camshaft position sensor A circuit (bank 1 or single sensor) I changed the distributer pick up or stator and now it will not start at all!! the past 4 weeks i have replaced the battery both oxy sensors crank sensor. after replacing the part do you erase the codes? please help rob
Aug 21, 2010 at 1:18 PM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Did you check the sensor electrical circuits/connector. Violet wire with white tracer is ref voltage around 5 volts, key on. Use digital multimeter. The black wire with lite blue tracer is ground. To check any ground going to the computer, even constant ground, I use an led with resistor. The ref voltage and ground are shared circuits, shared by several other circuits.

yes, erase the codes, or unplugging the negative battery cable usually take care of it. unplug it for about fifteen minutes
Sep 29, 2020 at 4:11 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle