1996 Jeep Cherokee

97,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
BRICRIS2000
  • MEMBER
  • 1 POST
i have a 1996 jeep cherokee and the car runs ok but wen at idle or traveling at very low speeds it stalls. I have changed the throttle position sensor, crank position sensor, the coil, distributor cap and rotor, so i dont know what could be causing the stall... thoughts?
Oct 30, 2010 at 12:56 PM
Avatar
CJ MEDEVAC
  • ✓Experienced Mechanic
  • 11,000 POSTS
Wife had similar issues with her Ford Escape

I was told it could be the IAC (Intake Air Control) It controls the Idle by "Bypassing" your throttle butterfly.

Basically at low RPM, fuel is not completely controlled to keep idle in check......But the incoming combustion air is.

This thing is located on the intake (where your air cleaner hose stops and the Throttle Body begins) It has a Motor on it, Wife's had 2 bolts, yours may have more.

It can be cleaned (which I did, just to verify the problem), but I feared that since it had right at 100,000 miles..........Under $50 was not a lot to invest for a new one........Now I have an Emergency Spare one!



https://www.2carpros.com/topics/engine-mechanical/intake-valve









Your Turn

The Medic


https://www.2carpros.com/forum/automotive_pictures/411289_WILLY_ALWAYS_KEEPS__A_STRAIGHT_FACE_1.jpg

Oct 30, 2010 at 3:54 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle