Idle screw setting

Tiny
DWAYNE MICHNAL
  • MEMBER
  • 1994 MAZDA 626
  • 2.0L
  • 4 CYL
  • 2WD
  • MANUAL
  • 161,000 MILES
I understand about using the 10 pin and ground in diagnostic mode. But what was the general setting on the idle screw ( turns out from bottom ) on my car?
Wednesday, September 28th, 2016 AT 12:41 AM

2 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
That is not an idle setting. It is an idle stop and should never be touched once it is set from the factory. The idle speed is entirely controlled by the computer metering air.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Wednesday, September 28th, 2016 AT 6:12 AM
Tiny
AL514
  • MECHANIC
  • 4,692 POSTS
Agree fully with wrenchtech, never touch those screws.
Was this
answer
helpful?
Yes
No
Wednesday, September 28th, 2016 AT 12:03 PM

Please login or register to post a reply.

Related General Content

GUIDE
Inquire Here

Sponsored links