Antifreeze in the oil. What is the torque of the engine head bolts

2010 CHEVROLET EQUINOX
46 MILES • 2.4L • 4 CYL • 4WD • AUTOMATIC
Avatar
ORTIZ.JESUS47
  • MEMBER
  • 1 POST
It looks like it is passing antifreeze to the oil. I would like to know the torque of the engine head bolts and I would also like to know the sequence of how to tighten each of the screws.
Dec 31, 2016 at 3:02 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,367 POSTS
First pass is 22 foot pounds. Second pass is 155 degrees.

You did not say what the symptom is, so I do not know what led you to the conclusion you arrived at. Do you think tightening the bolts is going to solve a leaking head gasket, or are you replacing the head gasket?

These are "torque-to-yield" head bolts. That means they are designed to stretch one time when they are installed. They must be replaced once they have been removed. If you try to reuse them, you will not achieve the correct clamping force.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Dec 31, 2016 at 4:16 AM
Avatar
STEVE W.
  • ✓Experienced Mechanic
  • 15,295 POSTS
Worse, reuse them and they can snap in the block, so you get to remove them again. remove the broken stub and replace the new gasket and buy the new bolts that you should have anyway.
Dec 31, 2016 at 11:18 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.