2006 Hyundai Tiburon Just Replaced Spindle

Tiny
82EDWARDS
  • MEMBER
  • 2006 HYUNDAI TIBURON
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 74,000 MILES
I just finished replacing the spindle, wheel bearing, hub and roter on my girlfriends tiburon. She hit a pot hole and almost rolled her car. This busted the wheel bearing and since she did not tell me it also caused damage to the spindle and hub. Now that I have it all back together, the engine reves up and there is a pause before the tires start to spin. Then the tires start to spin, but in a few seconds the tires will stop spinning again while the engine is still reved.

Any ideas?
Wednesday, February 3rd, 2010 AT 10:03 PM

3 Replies

Tiny
BMRFIXIT
  • MECHANIC
  • 19,053 POSTS
Check and make sure that the axle back in the tranny
as it is possible that came out of the tranny side
Was this
answer
helpful?
Yes
No
Wednesday, February 3rd, 2010 AT 10:50 PM
Tiny
82EDWARDS
  • MEMBER
  • 2 POSTS
The axle still appears to be in the tranny. With the drive shaft nut off, there is a slight give when I pull or push on the axle. It will not come out, and it does not go in and stay in when I push in on it. Should I wack it with a hammer or something? Is it possible that either of the joints are out of alignment?
Was this
answer
helpful?
Yes
No
Thursday, February 4th, 2010 AT 9:31 AM
Tiny
BMRFIXIT
  • MECHANIC
  • 19,053 POSTS
Small tap should be OK

also if axle is broken will act the same way too
or if was pulled out of place
Was this
answer
helpful?
Yes
No
Thursday, February 4th, 2010 AT 9:31 PM

Please login or register to post a reply.

Sponsored links