brake pedal gets very firm and the front right brakes are sticking

2007 CHEVROLET TRAILBLAZER
134,000 MILES • 4.2L • V6 • 4WD • AUTOMATIC
Avatar
HUNTERSCHULTZ24
  • MEMBER
  • 2 POSTS
When I leave my house brakes are normal after a very short time, I'd say 3-5 minutes the brakes pedal gets very firm and the front right brakes are sticking. I have replaced the brake pads, the caliper, and the brake hose. I'm at a loss, I have no idea what to do next. please help.
Jun 1, 2022 at 4:32 PM
Advertisement
Avatar
STRAILER
  • ✓ASE Certified Mechanic
  • 54,832 POSTS
  • ASE Certified Mechanic
This is common when the brake master cylinder needs to be replaced or the push rod in the brake booster is adjusted out too far. To check if the push rod from the booster is the problem slimly loosen the brake master mounting bolts two turns to see if the left front wheel starts to turn, if so, remove the master, (you can keep the lines connected) and turn the push rod adjuster in two turns and it should fix the problem. Let us know what happens and please upload pictures or videos of the problem.
Jun 2, 2022 at 1:44 PM
Avatar
HUNTERSCHULTZ24
  • MEMBER
  • 2 POSTS
The front brakes are dragging left and right side. I'm not sure what could cause both sides to drag. Help
Jun 6, 2022 at 1:24 PM (Merged)
Avatar
STRAILER
  • ✓ASE Certified Mechanic
  • 54,832 POSTS
  • ASE Certified Mechanic
Did you read my first response? Please loosen the brake master mounting bolts three turns after the car is jacked up in the front to see if the wheels turn.
Jun 6, 2022 at 1:25 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.