1999 Honda Prelude clutch not working

1999 HONDA PRELUDE
80,000 MILES • 4 CYL • FWD • MANUAL
Avatar
MANNYC
  • MEMBER
  • 1 POST
I'm having a problem w/ the clutch when you step on the clutch it goes all the way down but won't come back up after replacing the clutch. I bled the system, replaced both the master cylinder and the slave cylinder (doesn't use wire it's self adjusting). The clutch is still the same... I took off the tranny off and checked the clutch, bearing, and fork they all look good. Could you point me in the right direction, thank you.
May 11, 2008 at 5:48 PM
Advertisement
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
Hi there,

I do feel that it is a hydraulic problem. I would re check the bleeding make sure all connections are tight and don't let it run low on fluid while bleeding ,

Mark (mhpautos)
May 11, 2008 at 9:35 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.