2001 Honda Civic 2001 Honda Gas Refill Door Release

2001 HONDA CIVIC
107,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
SLAMOREUX
  • MEMBER
  • 2 POSTS
My gas cap release no longer works (although the trunk release works just fine). I'm about out of gas, and am looking for a way to get the lid open so I can put some gas in it and take it to get repaired.

Is there a way I can pop this door open without using the broken release lever ?

Also, is this something I can fix myself ?

Thanks for any help !
Dec 29, 2007 at 4:37 PM
Advertisement
Avatar
MHPAUTOS
  • ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Remove the trim in the boot from the back of the fuel filler, you may be able to trigger the release from there, if no access to the release, remove the trim at the lower edge of the rear door behind the filler, the cable will run through there, you may be able to follow it to the lock to open it.

Mark (mhpautos)
Dec 29, 2007 at 5:57 PM
Avatar
SLAMOREUX
  • MEMBER
  • 2 POSTS
Mark,

Your advice was right on target. I also picked up a replacement cable assembly for about $60, and replaced it in about an hour.

Thanks





[quote:a3e20ff2ca="mhpautos"]Remove the trim in the boot from the back of the fuel filler, you may be able to trigger the release from there, if no access to the release, remove the trim at the lower edge of the rear door behind the filler, the cable will run through there, you may be able to follow it to the lock to open it.

Mark (mhpautos)[/quote:a3e20ff2ca]
Jan 1, 2008 at 3:08 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.