2005 Honda Accord Car shakes at 60 MPH

2005 HONDA ACCORD
77,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
CHEWYSJU
  • MEMBER
  • 1 POST
Right when I hit 60 MPH my 2003 Honda Accord starts to shake, when I get over 70 it stops.

Any idea?

Thanks

John
Apr 25, 2008 at 1:29 PM
Advertisement
Avatar
LEGITIMATE007
  • ASE Certified Mechanic
  • 5,121 POSTS
  • ASE Certified Mechanic
your probably gonna need a front end allignment and tie rod ends or either or. usually front end allighnment
Apr 25, 2008 at 2:35 PM
Avatar
JOTAKAMI
  • MEMBER
  • 1 POST
I've got the exact same problem in my '04 accord, 94k miles... starts shaking at 60, stops at about 70, but only when I press the accelerator, and it shakes harder the more I press it.

The problem was first diagnosed by Tire Kingdom as a bent drive axle; fortunately I didn't get it fixed right there. I just yesterday took it to a Honda service center and they determined the drive axle is fine but something in the transmission is causing the problem. I don't know if it is a repairable problem, or even if it serious or just an annoyance. Since I'm selling the car in a few months, I'm going to leave it alone.

Just to be clear though, the problem is most definitely *not* alignment or wheel balance, nor is it the CV joint.
Jun 4, 2008 at 5:32 PM
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Hi ChewySJU, legitimate007, jotakami


There is probably something wrong with the torque converter.

Hi legitimate007, so all is well. Sorry did not reply to you earlier.
Jun 5, 2008 at 8:38 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.