1998 Honda Accord burping cooling system

1998 HONDA ACCORD
170,000 MILES • 4 CYL • FWD • MANUAL
Avatar
FROELICH23
  • MEMBER
  • 1 POST
my radiator cap was bad and sucked a lot of air into the system it was burped by a pro tech before i found out the cap was bad now ther is air in the line again how do i burp it my self
Nov 26, 2008 at 7:01 PM
Advertisement
Avatar
DAVE H
  • ✓ASE Certified Mechanic
  • 13,384 POSTS
  • ASE Certified Mechanic
with the engine cold/cool, start the engine Loosen the air bleed bolt (A) in the thermostat housing, then pour Honda All Season Antifreeze/Coolant Type 2 into the radiator to the bottom of the filler neck. Do not let coolant spill on any electrical parts or the paint. If the any coolant spills, rinse it off immediately. Tighten the bleed bolt as soon as coolant starts to run out in a steady stream. bleed bolt location


https://images.2carpros.com/forum/automotive_pictures/266999_bleed_2.jpg

Nov 27, 2008 at 6:00 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.