1986 Honda Accord cv joint problem

1986 HONDA ACCORD
87,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
PAPINCHAK
  • MEMBER
  • 1 POST
Is it possible for a brand new installed cv joint to be bad? We just had both sides replaced and the axle bearings replaced. Now there is a clicking sound. Took it back to mechanic, he said it was ok because there was not any grease coming from them. Any suggestions. Thanks, Kim
Feb 25, 2010 at 1:27 PM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
Hi Kim,

It is possible for new CV shafts to be bad and clicks.

Check the installation and tightening of linkages.

Sometimes it requires some running in before the clicking noise goes away.

Go to a large open space anf turn the steerint to almost full turn and drive the car slowly for a few rounds. Reverse the turning direction and if the noise goes away, it should be ok. If not, you should get the mechanic to have another look and let you know what causes the noise.
Feb 27, 2010 at 12:30 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle