Hesitating while accelerating

2006 LEXUS RX 350
196,434 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
BLESSING EWOBOR
  • MEMBER
  • 753 POSTS
Good morning, the vehicle is not functioning properly. after I have scanned it the only code found was "camshaft position "a" timing over retarded". Is it the sensor that is bad or what?
Oct 14, 2020 at 8:18 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
4DRTOM
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 467 POSTS
Hello,

Well, it's awfully suspect for sure. If the computer is thinking the timing is off or not working properly you would get a hesitation. So with the code matching the symptom it's a pretty good bet it has gone bad. Here is a picture of there locations I highlighted them in yellow there at the rear of the heads up against the firewall.
Let me know if your need anything else.
Tom
Images (Click to enlarge)
Attached Media
Attached Media
Oct 14, 2020 at 10:07 PM
Advertisement
Avatar
BLESSING EWOBOR
  • MEMBER
  • 753 POSTS
Good morning, thank you.
Would I replaced the two sensors or one?
Oct 23, 2020 at 7:09 PM
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,184 POSTS
this would be the sensor closest to the firewall (right side), but I have seen this code when the oil gets low or dirty. can you confirm clean and the proper level of engine oil?
Oct 27, 2020 at 2:01 PM
Avatar
BLESSING EWOBOR
  • MEMBER
  • 753 POSTS
Thank you, I will confirm if the engine is low.
Oct 28, 2020 at 7:19 AM