I can't get the fan back on because the fan mounting bracket bunks into the crankshaft pulley.
Jan 4, 2022 at 1:55 PM
Heater fan installation issue
1987 FORD CROWN VICTORIA
TRIPLEMINDS
- MEMBER
- 1 POST
Advertisement
JACOBANDNICKOLAS
- ✓ASE Certified Mechanic
- 110,194 POSTS
Hi,
The crankshaft pulley is at the front of the motor. This blower motor should be mounted under the hood in the firewall, passenger side. Is that correct?
Is the new motor the same size and design as the one you removed? Could you take a pic of what you are seeing and upload it for me to see?
Take a look through this link and let me know if it helps.
https://www.2carpros.com/articles/blower-fan-motor-works-on-high-speed-only
I will watch for your reply.
Take care,
Joe
The crankshaft pulley is at the front of the motor. This blower motor should be mounted under the hood in the firewall, passenger side. Is that correct?
Is the new motor the same size and design as the one you removed? Could you take a pic of what you are seeing and upload it for me to see?
Take a look through this link and let me know if it helps.
https://www.2carpros.com/articles/blower-fan-motor-works-on-high-speed-only
I will watch for your reply.
Take care,
Joe
Jan 4, 2022 at 6:25 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.