Heat on drivers side but not passenger

2007 DODGE CHARGER
90,100 MILES
Avatar
BDACEY
  • MEMBER
  • 2 POSTS
I am only getting heat on drivers side of car and cold on passenger side. I looked behind glove box and blend doors are working. Could problem be the blend door on drivers side and if so where is that located? Any help would be appreciated
Nov 20, 2013 at 6:36 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Does your vehicle have dual climate control? If so, then it is most likely a blend air door. Keep in mind, you only have one heater core. If one side gets heat, then the core is working and both should get heat. So, the blend air door is my first suspect. Both blend air doors are on the heater core box.
Nov 20, 2013 at 7:05 AM
Advertisement
Avatar
BDACEY
  • MEMBER
  • 2 POSTS
I do not have dual climate control so would you think it is stil blend air door problem?
Nov 20, 2013 at 7:19 AM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
If you don't have dual climate control, then there is only one blend air door. Make sure it is opening fully. Also, check direction vents to make sure they are functioning.
Nov 20, 2013 at 7:44 AM