Rough running, hard starting, set engine code 43.
Apr 3, 2018 at 1:40 PM
hard starting, set code 43
1994 PLYMOUTH VAN
HMFIXER
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Good afternoon.
Code 43 is for ignition primary circuit to the ignition coil. make sure the connector is good, clean and tight. no loose or damaged pins in the connector.
If they are good, verify a twelve volt signal to the coil with the key on. if that is all okay, replace the coil.
Roy
Code 43 is for ignition primary circuit to the ignition coil. make sure the connector is good, clean and tight. no loose or damaged pins in the connector.
If they are good, verify a twelve volt signal to the coil with the key on. if that is all okay, replace the coil.
Roy
Image (Click to enlarge)
Apr 3, 2018 at 3:14 PM
Advertisement