1994 GMC Sonoma

1994 GMC SONOMA
225,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
ENER
  • MEMBER
  • 1 POST
After I had clutch & fuel replaced, the ABS brake light stays on, could the mechanic have knocked something off or coinsidence?. I've had brake guys look at it but no one seems to know. I went online for recalls & it seems there was one for this item (Recall ID #'s 72432 & 72371).
Mar 15, 2010 at 12:27 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Try clearing it do below

Turn ignition on. Using a jumper wire, connect DLC terminal "H" to terminal "A" for 2 seconds. Remove jumper wire for one second. Again, jumper DLC connector terminal "H" to "A" for 2 seconds. Remove jumper wire. Fault codes are cleared when ANTILOCK and BRAKE lights illuminate, then turn off. Turn ignition off. Check to verify codes are cleared. See RETRIEVING CODES.
Mar 15, 2010 at 12:39 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle