SPONSORED LINKS

Possible fuel pump damaged by incorrect installation

Tiny
NATHAN CONATSER
  • MEMBER
  • 1987 GMC CHEVETTE
  • 2.8L
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 1,235 MILES
I had put the wrong cable which was negative to positive. It sparked. I replaced fuses, but not now my fuel pump isn't even coming on. Think by putting cables wrong way maybe somehow burnt my fuel pump up? Replaced fuses, but in order to start I have put gas in carburetor and needing answer.
SPONSORED LINKS
Monday, January 27th, 2020 AT 1:58 PM

1 Reply

Tiny
STEVE W.
  • MECHANIC
  • 13,487 POSTS
It shouldn't have burnt up the pump as there is a relay in the system that would have been open at the time. I would go over all of the fuses using a test light just to be sure. Plus I believe there is at least two fusible links in the wiring on them, it will look like a normal wire but have large rubber sections where the fuse link is soldered in place.
https://www.2carpros.com/articles/how-to-use-a-test-light-circuit-tester
If you find a few fuses that do not have power you will need to look at the links, they are normally near the battery or coming off the starter up to the fuse system.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, January 27th, 2020 AT 2:37 PM

Please login or register to post a reply.

Related Fuel System Fuel Pump Replace/Remove Content

Fuel Pump Replacement
GUIDE
Fuel Pump Replacement
When a fuel pump goes out it can do so one of two ways either it can quit and stop working or it can fail intermittently causing the engine to stall or not start.

Sponsored links