Fuel flow problem car feels heavy when trying to accelerate

253,255 MILES • 1.6L • 2WD • MANUAL
Avatar
ACQUAHFELIX
  • MEMBER
  • 5 POSTS
My vehicle occasionally stalls as if I have run out of fuel but not. My mechanic has changed the fuel pump twice as well as the fuel filter. Again as soon as the air condition is put on, the car becomes so heavy for want of better word that when you accelerate. it does not seem to pull as it should unless you again switch off the air-condition. My car has a manual transmission.
Dec 25, 2016 at 1:17 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
try cleaning throttle plate on both sides and IAC hole with choke cleaner first. check for a vacuum leak like a hose off broken etc.
Dec 25, 2016 at 11:09 PM
Avatar
ACQUAHFELIX
  • MEMBER
  • 5 POSTS
My Mechanic has already cleaned both throttle plate, but he has not cleaned the Idle air control valve. Will ask him to clean it and will revert. Thanks so much.
Dec 26, 2016 at 12:01 AM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
if this is a diesel we have not information on it as most here in USA have a 2.0l, but ours has a fuel pump module driver which the mechanic may have to scan for codes as that controls the fuel pump so that may be your cause other than that. we do not have any information for this. see picture.
Dec 26, 2016 at 1:40 AM
Avatar
ACQUAHFELIX
  • MEMBER
  • 5 POSTS
My vehicle is petrol engine Ford focus. My Mechanic has remove and cleaned IAC valve with choke carburetor cleaner as directed. I tried the vehicle thereafter on a shorter distance and it was cool. I'm yet to travel with it to finally confirm its success. Once again many thanks for your information.
Dec 26, 2016 at 12:25 PM
Avatar
ACQUAHFELIX
  • MEMBER
  • 5 POSTS
Again kindly help me my AC switch #1&2 does not work. Only 3&4 works. How do I resolve this issue too?
Dec 26, 2016 at 12:30 PM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
check the resistor normally by the blower motor see if power comes to it then goes out a lot of times the resistor burns out and doesnt' send power so no blower on that speed. if 4 is high check blower relay underhood.
Dec 26, 2016 at 9:41 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle