front signal lights wobble in their housing.

1995 ACURA INTEGRA
168,000 MILES
Avatar
INTEGGY95
  • MEMBER
  • 8 POSTS
The front turn signal lights stay in the bumper okay, but if you touch them, they wobble around and push inward, but don't fall out. What part is missing from it to cause that? I also have an issue with my front bumper wobbling on the drivers side. The nut is missing in order to hold it on correctly, but am unsure of what size nut it takes to keep it held in place.
Nov 13, 2013 at 10:14 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
The lens assembly is held in with screws they may be stripped and not tightening up, as for the bumper, they will me metric and probably 12mm x 1.25 best heads to a wrecked and get some there.
Nov 13, 2013 at 2:57 PM
Advertisement