Front brake locks up

154,000 MILES • 2.9L • V6 • 2WD • MANUAL
Avatar
JGKERCE2
  • MEMBER
  • 1 POST
After sitting for a few years I am getting my truck listed above back on the road.
New fuel pumps, tires, complete clutch rebuild, gas tank, rear brake rebuild, front bearings replaced. I've taken it out on a few short test drives and all seemed well. Yesterday after driving 15 miles the passenger side wheel locked up and was very hot. The rotor looked okay as well as the pads. I did replace the wheel bearings. I do not see any caliper leakage. Should I replace calipers or look at the master cylinder Thanks so much.
Aug 27, 2020 at 1:07 AM
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
Good afternoon,

I would replace the pads, rotors, calipers and brake hoses.

https://www.2carpros.com/articles/how-to-replace-front-brake-pads-and-rotors-fwd

Make sure you flush the brake system of all the old fluid. Otherwise you will contaminate all the new parts.

https://www.2carpros.com/articles/how-to-bleed-or-flush-a-car-brake-system

I would also replace the master cylinder as well.

https://www.2carpros.com/articles/how-to-replace-a-brake-master-cylinder

Roy

Apr 14, 2021 at 3:24 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle