96 Taurus Engine swap gone bad!

Avatar
OYRAY
  • MEMBER
  • 2 POSTS
1996 Ford Taurus LX 3.0 ltr. OHC V6 recently changed the engine (used) turned fine on the engine stand. But when installed hard to turn. Starter won't turn the engine but it will by hand. Replaced starter still no good. Checked all wiring and battey is charged. what did I do wrong?
Jul 6, 2007 at 3:51 AM
Avatar
JEWELLLSSS
  • MEMBER
  • 28 POSTS
one thing to check is if the motor came out of a different year of vehicle the flywheel could be different enough to have problems mounting to the torque converter. If this is the case then it will be hard to turn by hand and a starter will not turn it.
Jul 6, 2007 at 12:34 PM
Avatar
OYRAY
  • MEMBER
  • 2 POSTS
Holy COW! You will not believe this one! I mixed up the starter bolt's and the transmission bolt's! The tranny bolt's were 1/8" longer than the starter bolt's... They were hanging up on the torque converter making the engine impossible to turn!! OHMYGOODNESS! THanks for the suggestions thou!
Jul 22, 2007 at 1:54 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle