2004 Ford Taurus Fuse keeps blowing

Tiny
AMSCHAFE
  • MEMBER
  • 2004 FORD TAURUS
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 56,000 MILES
My ac compressor recently failed and at the same time my car started blowing a fuse. I bypassed the compressor and disconnected it electrically but the car still keeps blowing the fuse.
Tuesday, July 28th, 2009 AT 1:15 PM

3 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Hello, exactly which fuse? Is there a fuse number and amp rating? Fuse 22- 10 amp shows to be hot all the time. It not only serves the ac relay, but, pcm keep alive memory.

Fuse 28, 15 amp serves several circuits, 02 sensor--trans shift solenoid--canister vent-- coil side of ac clutch relay. That fuse circuit goes hot when you turn on the key.

Does the fuse blow before or after you turn on the key? I found some of this info in your owners manual, as far as what circuit/s the fuse serves.
Was this
answer
helpful?
Yes
No
+1
Tuesday, July 28th, 2009 AT 2:11 PM
Tiny
AMSCHAFE
  • MEMBER
  • 2 POSTS
It is the fuse 1.22-10 amp. According to the fuse diagram I have it serves the ac clutch relay, pcm and idle air. When the fuse blows the car will not idle and stalls. I am considering removing the AC relay also just in case that is causing it. I have disconnected the harness leading to the compressor already. It seems as though the fuse blows on startup. I think the first time it went the car was already running. The next 3 times occurred upon startup
Was this
answer
helpful?
Yes
No
+1
Tuesday, July 28th, 2009 AT 3:10 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
One of my databases showed the iac also. You might isolate the iac, see if the fuse still blows.
Was this
answer
helpful?
Yes
No
+1
Tuesday, July 28th, 2009 AT 4:00 PM

Please login or register to post a reply.

Sponsored links