1997 Ford Taurus

RD2020

MEMBER
1997 FORD TAURUS

Engine Mechanical problem
1997 Ford Taurus V8 Front Wheel Drive

where is the intake runner control located and how do I go about changing it?

Wednesday, September 1st, 2010 AT 3:29 PM

4 Replies

JACOBANDNICKOLAS

MECHANIC
110,047 POSTS

It is located on the left side of the engine mounted on the valve cover. Here is a picture. I hope it is big enough for you to see. It is number 18 on the picture. It unbolts and isn't that difficult to replace. Also, the only V6 that has the runner control is the 3.0L 4V.

Let me know if this helps.

Joe

Was this

answer

helpful?

Yes

No

Wednesday, September 1st, 2010 AT 8:56 PM

JACOBANDNICKOLAS

MECHANIC
110,047 POSTS

First, thanks for the positive feedback. Did it help you with your question?

Was this

answer

helpful?

Yes

No

Thursday, September 2nd, 2010 AT 9:00 PM

RD2020

MEMBER
4 POSTS

It did help somewhat but this is on a v8 sho motor. My obdII tester says it is the runner for bank 1. Would that put it behind the motor, closer to the firewall? Thanks again for the help.

Was this

answer

helpful?

Yes

No

Friday, September 3rd, 2010 AT 3:07 PM

JACOBANDNICKOLAS

MECHANIC
110,047 POSTS

It's the same place. If you are standing in front of the car, it is on the valve cover (center). Here is a picture of the SHO 3.4L V6. The runner control is number 20. I hope you can see it in the picture.