Ford Ranger Clutch problem

FORD RANGER
Avatar
MAYHEW75
  • MEMBER
  • 1 POST
I have a 2002 ford ranger man. transmission - The clutch would not engage this morning, The fluid was gone, so I replaced, and bled the system. figured this would do the trick. (It had been sloppy for a few days.) Upon starting the car, I cannot get the car into gear. was the system bled wrong? Should I try and repeat all steps?
Nov 20, 2007 at 3:37 AM
Avatar
AUTOPRO
  • ✓Experienced Mechanic
  • 45 POSTS
These clutches bleed themselves but the fact that the fluid was gone means the clutch master or secondary cylinder is leaking so I would use a flashlight and look under the dash at the rear of the clutch master and at the lowest part of the bell housing of the transmission and look for fluid. I have seen the secondary cylinder leaking cause this problem FYI.

Here are two video to help us see what's going on and how to fix it.

this video who the job being done on a similar car the procedure is the same.

https://youtu.be/JpzefqEeVGE?si=swN61q1MPyivB1cv


This guide may help as well

https://www.2carpros.com/articles/clutch-doesnt-work-sometimes-or-not-at-all

Please go over these guides and get back to us.
Nov 20, 2007 at 11:20 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle